An Experimental Study on Simultaneous Use of Phase Change Material and Wind Stream to Increase Electrical Efficiency of Photovoltaic Module

Lotfi, Marzieh; Shiravi, Amir Hossein; Norouzi, Ahmad Reza; Chamaei, Yasin; Firoozzadeh, Mohammad

doi:10.22034/jrenew.2024.192248

An Experimental Study on Simultaneous Use of Phase Change Material and Wind Stream to Increase Electrical Efficiency of Photovoltaic Module

Document Type : Original Article

Authors

Marzieh Lotfi ¹

Amir Hossein Shiravi ²

Ahmad Reza Norouzi ¹

Yasin Chamaei ²

Mohammad Firoozzadeh ²

¹ Department of Chemical Engineering, Jundi-Shapur University of Technology, Dezful, Iran

² Department of Mechanical Engineering, Jundi-Shapur University of Technology, Dezful, Iran

https://doi.org/10.22034/jrenew.2024.192248

Abstract

In recent years, generation of electricity through photovoltaic power plants has developed rapidly. The availability of sunlight and the appropriate return on investment are two important factors in the impressive growth of photovoltaic (PV) power plants. Unfortunately, increase in PV cell temperature is one the main defects of them and it has a significant negative effect on the electrical efficiency of PV panels. In this paper, using paraffin as phase change material (PCM) on the performance of photovoltaic cells has been investigated experimentally. The material has melting point of about 58˚C. Also, the effect of airflow at two different velocities of 2 and 4 km/h in presence of paraffin have been tested, too. To have a better management on performing the tests, a solar simulator was used, so that the solar irradiation and wind stream were supplied by means of a projector and an industrial blower, respectively. Results showed 13-16˚C decrease in PV temperature for the three modified cases, in comparison with the conventional one. Moreover, the effect of mentioned temperature reduction on both electrical efficiency and output power were also studied. Finally, the environmental effects of commissioning a 10-kW PV power plant were checked by using RETScreen software. Accordingly, the annual reduction of carbon dioxide (CO2) emission is estimated for all considered cases.

Keywords

Photovoltaic

Phase change materials

Electrical efficiency

Solar energy

Environment

Subjects

Solar Energy

مراجع

[1] A. D. Shaeri-nejad, The effect of smart glasses on the performance of a solar refrigeration in a building in Bushehr, Iranian Journal of Mechanical Engineering, vol. 20, no. 4, pp. 97-117, 2018.

[2] M. R. Saffarian, M. Moravej, and M. H. Doranehgard, Heat transfer enhancement in a flat plate solar collector with different flow path shapes using nanofluid, Renewable Energy, vol. 146, pp. 2316-2329, 2020.

[3] H. Adun et al., Synthesis and application of ternary nanofluid for photovoltaic-thermal system: Comparative analysis of energy and exergy performance with single and hybrid nanofluids, Energies, vol. 14, no. 15, p. 4434, 2021.

[4] A. Dhass, E. Natarajan, and P. Lakshmi, An investigation of temperature effects on solar photovoltaic cells and modules, International Journal of Engineering Transaction B: Applications, vol. 27, no. 11, pp. 1713-1722, 2014, doi: doi: 10.5829/idosi.ije.2014.27.11b.09.

[5] A. H. Shiravi and M. Firoozzadeh, Performance Assessment of a finned Photovoltaic Module exposed to an Air Stream; An Experimental Study, Journal of the Brazilian Society of Mechanical Sciences and Engineering, vol. 44, no. 11, p. 535, 2022.

[6] M. Firoozzadeh, M. Lotfi, A. H. Shiravi, and M. Rajabzadeh Dezfuli, An experimental study on using water streaks and water film over PV module to enhance the electrical efficiency, Environmental Science and Pollution Research, pp. 1-13, 2023.

[7] H. A. Hasan et al., Experimental Evaluation of the Thermoelectrical Performance of Photovoltaic-Thermal Systems with a Water-Cooled Heat Sink, Sustainability, vol. 14, no. 16, p. 10231, 2022.

[8] M. Firoozzadeh, A. H. Shiravi, M. Lotfi, S. Aidarova, and A. Sharipova, Optimum Concentration of Carbon Black Aqueous Nanofluid as Coolant of Photovoltaic Modules: A Case Study, Energy, vol. 225, p. 120219, 2021, doi: doi: 10.1016/j.energy.2021.120219.

[9] M. Ahmadinejad, A. Soleimani, and A. Gerami, The effects of a novel baffle-based collector on the performance of a photovoltaic/thermal system using SWCNT/Water nanofluid, Thermal Science and Engineering Progress, vol. 34, p. 101443, 2022.

[10] M. Firoozzadeh, M. Lotfi, and A. H. Shiravi, An Experimental Study on Simultaneous Use of Metal Fins and Mirror to Improve the Performance of Photovoltaic Panels, Sustainability, vol. 14, p. 16986, 2022.

[11] F. Sarhaddi, S. Farahat, H. Ajam, A. Behzadmehr, and M. M. Adeli, An improved thermal and electrical model for a solar photovoltaic thermal (PV/T) air collector, Applied Energy, vol. 87, no. 7, pp. 2328-2339, 2010.

[12] M. Naghavi, A. Esmaeilzadeh, B. Singh, B. Ang, T. Yoon, and K. Ong, Experimental and numerical assessments of underlying natural air movement on PV modules temperature, Solar Energy, vol. 216, pp. 610-622, 2021.

[13] S. Krauter, Increased electrical yield via water flow over the front of photovoltaic panels, Solar Energy Materials and Solar Cells, vol. 82, no. 1-2, pp. 131-137, 2004.

[14] H. M. Maghrabie, A. Mohamed, A. M. Fahmy, and A. A. A. Samee, Performance enhancement of PV panels using phase change material (PCM): An experimental implementation, Case Studies in Thermal Engineering, vol. 42, p. 102741, 2023.

[15] N. Nesari, An investigation on employing PCM in order to decrease the temperature of PV panel, Sixth international conference on novel energy saving methods, vol. 28, no. 3, pp. 111-131, 2016.

[16] A. Bria, B. Raillani, D. Chaatouf, M. Salhi, S. Amraqui, and A. Mezrhab, Effect of PCM Thickness on the Performance of the Finned PV/PCM System, Materials Today: Proceedings, vol. 72, pp. 3617-3625, 2023.

[17] F. Hachem, B. Abdulhay, M. Ramadan, H. El Hage, M. G. El Rab, and M. Khaled, Improving the performance of photovoltaic cells using pure and combined phase change materials–Experiments and transient energy balance, Renewable Energy, vol. 107, pp. 567-575, 2017.

[18] M. Firoozzadeh, A. H. Shiravi, and M. Shafiee, Using Polyethylene Glycol, as a Phase Change Material and Fins for the Cooling of Photovoltaic Cells of the Crystalline Type (in Persian), Amirkabir Journal of Mechanical Engineering, vol. 52, no. 6, pp. 101-110, 2018.

[19] M. Firoozzadeh and A. H. Shiravi, Simultaneous Use of Porous Medium and Phase Change Material as Coolant of Photovoltaic Modules; Thermodynamic Analysis, Journal of Energy Storage, vol. 54, p. 105276, 2022.

[20] E. Ebrahimi, Experimental investigation on the performance increment of a PV module using PCM and CuO nanofluid, Amirkabir Journal of Mechanical Engineering, vol. 52, no. 2, pp. 281-296, 2020.

[21] M. Baygi and M. Ameli, Design and build a cooling system in order to efficiency increament by PCM, Sharif Journal of Mechanical Engineering, vol. 323, no. 1, pp. 77-82, 2019.

[22] M. Sardarabadi, M. Passandideh-Fard, M.-J. Maghrebi, and M. Ghazikhani, Experimental study of using both ZnO/water nanofluid and phase change material (PCM) in photovoltaic thermal systems, Solar Energy Materials and Solar Cells, vol. 161, pp. 62-69, 2017.

[23] M. Hemmat Esfe, M. H. Kamyab, and M. Valadkhani, Application of nanofluids and fluids in photovoltaic thermal system: An updated review, Solar Energy, vol. 199, pp. 796-818, 2020.

[24] E. M. Alawadhi, Thermal analysis of a building brick containing phase change material, Energy and buildings, vol. 40, no. 3, pp. 351-357, 2008.

[25] K. Nagano, T. Mochida, S. Takeda, R. Domański, and M. Rebow, Thermal characteristics of manganese (II) nitrate hexahydrate as a phase change material for cooling systems, Applied Thermal Engineering, vol. 23, no. 2, pp. 229-241, 2003.

[26] M. Firoozzadeh, A. H. Shiravi, and M. Shafiee, Thermodynamics assessment on cooling photovoltaic modules by phase change materials (PCMs) in critical operating temperature, Journal of thermal analysis and calorimetry, vol. 144, no. 4, pp. 1239-1251, 2020/04/13 2021.

[27] M. Rezvanpour, D. Borooghani, F. Torabi, and M. Pazoki, Using CaCl2· 6H2O as a phase change material for thermo-regulation and enhancing photovoltaic panels’ conversion efficiency: Experimental study and TRNSYS validation, Renewable Energy, vol. 146, pp. 1907-1921, 2020.

[28] E. Mettawee and A. Ead, Energy saving in building with latent heat storage, Int. J. of Thermal & Environmental Engineering, vol. 5, no. 1, pp. 21-30, 2013.

[29] P. Tatsidjodoung, N. Le Pierrès, and L. Luo, A review of potential materials for thermal energy storage in building applications, Renewable and Sustainable Energy Reviews, vol. 18, pp. 327-349, 2013.

[30] Rubitherm-GmbH, Available at: https://www.rubitherm.eu/.

[31] A. Waqas and J. Ji, Thermal management of conventional PV panel using PCM with movable shutters–A numerical study, Solar Energy, vol. 158, pp. 797-807, 2017.

[32] M. Lotfi, A. H. Shiravi, and M. Firoozzadeh, Experimental Study on Simultaneous Use of Phase Change Material and Reflector to Enhance the Performance of Photovoltaic Modules, Journal of Energy Storage, vol. 55, 2022.

[33] J. Zhao, T. Ma, Z. Li, and A. Song, Year-round performance analysis of a photovoltaic panel coupled with phase change material, Applied Energy, vol. 245, pp. 51-64, 2019.

[34] Z. Luo, N. Zhu, P. Hu, F. Lei, and Y. Zhang, Simulation study on performance of PV-PCM-TE system for year-round analysis, Renewable Energy, vol. 195, pp. 263-273, 2022.

[35] M. Sharaf, A. Huzayyin, and M. S. Yousef, Performance enhancement of photovoltaic cells using phase change material (PCM) in winter, Alexandria Engineering Journal, vol. 61, no. 6, pp. 4229-4239, 2022.